When you go out to drive, especially on long vacations, you should pay special attention to the breakdown of your car. Once this kind of phenomenon occurs, it will not only affect the travel mood, but also make car owners feel embarrassed and have a sense of a dilemma. As the saying goes, “Whoever has it is better than you own”, mastering certain emergency car repair skills will definitely allow you to travel with confidence and have a happy vacation!
Crash 1: Oil pipe broken
The car should be equipped with a rubber plastic pipe with the same diameter as the oil pipe for socketing. If the socketing is not tight enough, it can be Use iron wires at both ends of the hose to prevent oil leakage.
Crash 2: Oil pipe rupture
When the oil pipe ruptures, wipe the rupture, apply soap, and wrap a cloth or tape around the oil pipe Crack and tie with wire, and then apply a layer of soap.
Emergency 3: Oil leakage from the oil pipe joint
You can wrap cotton yarn around the lower edge of the horn, and then tighten the oil pipe nut and oil pipe joint; Chew bubble gum or maltose into a paste, apply it to the mouth of the tubing nut, and seal it after it dries.
Emergency 4: Fuel tank damage
When the motor vehicle is in use, it is found that the fuel tank leaks. Bubble gum is applied to the oil spill to temporarily block it; repair it with epoxy adhesive for better results.
Emergency 5: The sedimentation cup is broken
Cover the inlet and outlet pipes of the sedimentation cup with a tape tube or plastic tube, so that the oil does not pass through the sedimentation cup directly .
Emergency 6: Rupture of the inlet and outlet hoses
If the rupture is small, you can use a cloth coated with a layer of soap to wrap the leaking area; If the rupture is large, cut off the rupture of the hose, put a bamboo pipe or iron pipe in the middle, and tie it with iron wire.
Breakdown 7: Valve spring is broken
The broken spring can be removed, and the two broken sections can be installed in reverse, and it can be used . If the spring is broken into several sections, the cylinder’s intake and exhaust valve adjustment screws can be removed to keep the valve closed and the cylinder to stop working.