Nine tips for car maintenance must be seen when driving on the road, to ensure that driving is disturbed, and that you know how to repair when you encounter problems.
One, the fan belt is broken. You can tie the broken belt in series with iron wire or take the method of starting and stopping to drive the car away.
Second, the valve spring is broken. The broken spring can be removed, and the two broken sections can be installed in reverse, and it can be used. If the spring is broken into several sections, the intake and exhaust valve adjustment screws of the cylinder can be removed to keep the valve closed and the cylinder to stop working.
Three, the inlet and outlet hoses are broken. When the rupture is not large, use a cloth coated with a layer of soap to wrap the leak; if the rupture is large, cut off the rupture of the hose, put a bamboo or iron pipe in the middle, and tie it with iron wire.
Fourth, the accumulation cup breaks. Cover the inlet and outlet pipes of the sedimentation cup with a tape tube or plastic tube, so that the oil does not pass through the sedimentation cup.
5. Fuel tank damage. When the flexible car is in use, if it is found that the fuel tank leaks, the oil leak can be wiped clean, and the oil leak can be coated with soap or bubble gum to temporarily block it; repair it with epoxy resin adhesive, the effect of car maintenance is better.
Six, oil leakage and water leakage. According to the size of the trachoma, choose an electrician’s fuse of the corresponding specification, and slightly smash it into the trachoma with a hand hammer to remove oil leakage and water leakage.
Seven, the oil pipe joint leaks oil. You can use cotton yarn to wrap around the lower edge of the horn, and then tighten the tubing nut and tubing joint; you can also chew bubble gum or maltose into a paste, apply it to the mouth of the tubing nut, and seal it after it dries.
Eighth, the oil pipe broke. When the tubing breaks, clean the break, apply soap, wrap a cloth or tape around the break of the tubing, tie it tightly with wire, and then apply a layer of soap.
Nine, the oil pipe is broken. When the oil pipe is broken, find a rubber or plastic pipe that is suitable for the diameter of the oil pipe. If the socket is not tight enough, the two ends should be tied with iron wire to avoid oil leakage.